RoadBikeReview.com's Forum Archives - General


Archive Home >> General(1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 )


Computer Woes(4 posts)

Computer WoesJoshua
May 10, 2002 8:24 AM
If anyone could help me that would be great ( I have'nt been let down yet by you guys) I have a Sigma bc1400 on my bike, the leads that go into the mount to feed the computer information tend to come off frequently. Does anyone have a good trick to keep these secure. Thanks
Anything in there you can crimp or bend?retro
May 10, 2002 9:05 AM
I don't know that computer, but when I've had similar problems on others, it's usually been possible either to crimp the female part of the connection a little or to put a very slight bend in the male end, on the end of the wire, where it plugs in. Keeps it from rattling loose.
re: Computer WoesJekyll
May 10, 2002 9:15 AM
Are you talking about the cadence wires? The wheel sensor wires don't plug in - they are soldered into the mount.
My cadence wires used to come off - a little hot glue - no further problems.
silicone seal or caulkjohnrg
May 10, 2002 10:23 PM
I've used a drop of silicone seal on my old sigma where the wires hang from the bar mount.