RoadBikeReview.com's Forum Archives - General


Archive Home >> General(1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 )


Campagnolo Ergobrain Computer Set Up...(4 posts)

Campagnolo Ergobrain Computer Set Up...DannyBoy
Mar 6, 2002 6:02 PM
Mine was set up fine and has worked fine for the last 500 miles or so. It still is except for some reason when I'm on the small ring and bigest sprocket it doesn't show on the display anymore (either the numeric 'teeth' display, or pictorial), apart from that it's fine??????

Any idea what's gone on?
Try cleaning the contacts...Slipstream
Mar 6, 2002 7:41 PM
What kind of conditions have you been riding in? Try removing the computer and thoroughly clean and dry the contacts.

If that doesn't work, then the problem may be in your ergo sensors. Clean and dry them.

If that doesn't work, then the check the contacts in the shifters. You know the drill.

If that doesn't work, try cleaning and drying the shims that go on the ergo lever mount.

Good luck.
Try cleaning the contacts...DY
Mar 6, 2002 9:28 PM
Did yours show when you were in the small ring and the lowest gear before? Mine has always been like that from the start....I thought it was normal for when I was in "1st" gear. Maybe it isn't.
All gears show correctly...Slipstream
Mar 7, 2002 5:11 AM
I have not had any problems so far...

I was very careful during the install--took me 3 1/2 hours--but it worked perfectly from the start and I have not had any problems.

Now that I know what I am doing, and where all those parts go, I could probably do it now in under an hour. That old learning curve.