|Need help after screwing up NiteRider light system||Dog|
Oct 3, 2001 6:17 AM
| Ever start messing with something before reading the manual?
I recently bought a NiteRider Digital Pro 12 LCD light system (recommended by several here). I accidentally started the calibration sequence. Now, even after full charge, the display shows only 15 minutes of power available at 32 watts (should be about 1.5 hours), and goes into reserve mode prematurely and turns off, long before it should. The battery had been fully charged before the subsequent tests, but I don't know whether it was when I triggered the calibration mode. This was only after a couple of charge/discharge cycles.
Is there a way to reset the computer so that it accurately controls the power? Have I harmed the battery or computer?
Any info would be appreciated. There is nothing helpful on NiteRider's site. Thanks.
Oct 3, 2001 6:30 AM
|They're great to deal with on the phone and have sent me replacement stuff free of charge. I bet they'd help you out or take pity on the poor fool namd Dog. Good luck.|
|Ride with a full moon-don't howl??? nm||MB1|
Oct 3, 2001 6:36 AM