RoadBikeReview.com's Forum Archives - Components


Archive Home >> Components(1 2 3 4 5 6 7 8 9 10 )


Shimano chain help(2 posts)

Shimano chain helpBreakfast
Aug 25, 2003 12:00 PM
On a Ultegra/XT 9-speed chain that has lost a roller inside of a link and then has been separated using a standard chain breaker tool, and had the roller replaced from a piece of spare chain and then re-assembled with the same standard chain breaker tool be OK to ride on again? Or, is the integrity of the pin been compromised?

I noticed a missing roller on only one link in my chain that has maybe 30 hours use on a MTB. I can't see why it cracked and came off except that it did.
No!the bull
Aug 25, 2003 1:56 PM
You should remove the pin and install the link thing.
You know the one that you press in then snap off the tip.
Reusing a roller off peice of leftover chain is fine as long as it is 9 speed.