RoadBikeReview.com's Forum Archives - Components


Archive Home >> Components(1 2 3 4 5 6 7 8 9 10 )


Help! trouble setting up Campy Ergobrain(3 posts)

Help! trouble setting up Campy Ergobraingsxrawd
Jan 11, 2003 5:56 PM
the computer will not read the correct cog on the rear. It always read one cog bigger. So when I'm on the smallest cog the computer will tthink i'm on the second to the smallest. I tried resetting it but still no luck :(
Anyone have any suggestions?
check wheel size, check cadence sensorweiwentg
Jan 12, 2003 6:59 AM
it sounds like the computer thinks you're going slower than you are. check the wheel size. also try resetting the computer with cadence off, and manually selecting the cassette. then see if it reads correctly.
re: Help! trouble setting up Campy Ergobraingschiener
Jan 12, 2003 10:15 AM
If all else has failed...check to be sure that when you installed the right side interface sensor that you shifted to the lowest gear and that it was inserted with the rotary ring positioned as shown in the installation instructions... hope this helps...