RoadBikeReview.com's Forum Archives - Components


Archive Home >> Components(1 2 3 4 5 6 7 8 9 10 )


Chorus Ergolevers: ? about installation(5 posts)

Chorus Ergolevers: ? about installationed11
Oct 16, 2002 4:54 AM
As stupid as this sounds, I cannot figure out where the 5 mm bolt is to loosen the brake for installation. The instructions are not specific enough for me, and I don't want to break anything. Do I need to remove the rubber on the top of the brake to reach it?
Yes. you have to pull back the hood a bit I pulled back the topOld_school_nik
Oct 16, 2002 5:42 AM
of the hood, but some unroll the bottom of the hood a bit to get to the screw on the outer portion of the lever - I was concerned to rip the hood as well, but if you are reasonably careful you shouldn't have a problem - if you have a long 5mm "y" allen wrench, that is best or else turn the allen key the long way. good luck,

-Nik
Thanksed11
Oct 16, 2002 6:19 AM
Just wanted to make sure.
Installation procedureCalvin
Oct 16, 2002 8:55 AM
Also see Lever Installation.
Thanks again: Installation procedureed11
Oct 16, 2002 9:09 AM
Seems awkward to pull the stiff rubber down. But that's what i'll do. Thanks.