RoadBikeReview.com's Forum Archives - Components


Archive Home >> Components(1 2 3 4 5 6 7 8 9 10 )


Tightening Campy Ergopower Levers(3 posts)

Tightening Campy Ergopower LeversVelocipedio
Jul 28, 2001 7:23 AM
The clamps holding my campy levers to my handlebars are a little loose -- they creak a bit when I climb. I understand there's a bolt accessible through the front of the lever to tighten the clamp, but I can't seem to find it. Any ideas how I could get at it?
re: Tightening Campy Ergopower LeversCliff Oates
Jul 28, 2001 7:37 AM
If you peel back the hoods, you will see it. The bolt is just inside of where the derailleur cable is routed and takes a 5mm allen wrench. You can also stick the wrench in under the hoods from the front on the outside of the lever.
Got it, thanks...Velocipedio
Jul 28, 2001 8:57 AM
Went out to the garage and though "gee, I wonder what I'll see if I peel back the hoods" and voila! Thanks. Squeaking is gone now.